
E8a Emulator User's Manual 4. Preparations for Debugging
R20UT0541EJ0601 Rev.6.01 Page 56 of 124
Aug 25, 2011
4.2.3 Setting the [Program Flash] Mode
The following describes the procedures when the emulator is used as the programming tool. The load module to be
downloaded to the new workspace is registered and programmed.
(a) Select the new project workspace.
Figure 4.21 [New Project Workspace] Dialog Box
(b) Select the target MCU and click the [Next] button.
Figure 4.22 [Setting the Target System for Debugging] Dialog Box
Comentarios a estos manuales