Renesas M3062PT2-EPB Manual de usuario descargar pdf (Pagina 90)

M3062PT2-EPB User’s Manual 4. Hardware Specifications

R20UT0211EJ0300 Aug 16, 2012 Page 90 of 104

Rev.3.00

4.6 Notes on Using This Emulator

Notes on using this emulator are listed below. When debugging the MCU using the emulator, be careful about the following

precautions.

IMPORTANT

Note on the Version of the Emulator Debugger:

 Be sure to use this product with one of the following emulator debuggers.

1. M16C R8C PC7501 Emulator debugger V.1.01 Release 00 or later

2. M3T-PD30F V.2.20 Release 1 or later

Note on Selecting the MCU File:

 Select the MCU file “M16C62P_512.mcu” at emulator startup.

Notes on Downloading Firmware:

 Before using this product for the first time, it is necessary to download the dedicated firmware (emulator’s

control software installed in the flash memory in the PC7501). Please note that, to do this, it is necessary to

start up the emulator main unit in maintenance mode. For downloading firmware, see "2.7 Downloading

Firmware" (page 28). Once the firmware has been downloaded, the product can be used by simply turning on

the power.

 Do n

ot shu

t off the power while downloading the firmware. If this happens, the product will not start up

properly. If the power is shut off unexpectedly, redownload the firmware.

 Download the firmware with the user system not connected.

Notes on Self-check:

 If the self-check does not result normally (excluding user system errors), the emulation probe may be damaged.

Then contact your local distributor.

 Run the self-check with the user system not connected.

Note on Quitting the Emulator Debugger:

 To restart the emulator debugger, always shut power to the PC7501 off once and then on again.

Note on Display of MCU Status:

 "MCU status" you can refer to in the MCU tab of the MCU Setting dialog box of the emulator debugger shows

pin levels of the user system. Make sure that proper pin levels are specified according to the mode you use.

(1) When single-chip mode is used:

CNVss: Low

(2) When memory expansion mode 16-bit data bus width is used:

CNVss: Low, BYTE: Low, HOLD#: High, RDY#: High

(3) When memory expansion mode 8-bit data bus width is used:

CNVss: Low, BYTE: High, HOLD#: High, RDY#: High

(4) When microprocessor mode 16-bit data bus width is used:

CNVss: High, BYTE: Low, HOLD#: High, RDY#: High

(5) When microprocessor mode 8-bit data bus width is used:

CNVss: High, BYTE: High, HOLD#: High, RDY#: High

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 103 104

Comentarios a estos manuales

Sin comentarios

Renesas M3062PT2-EPB Manual de usuario Pagina 90

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Renesas M3062PT2-EPB