Renesas SuperH SH7280 Series Manual de usuario descargar pdf (Pagina 113)

9.4. List of Error Information on Center Display

Center display status Descriptions

"0","0" Programming is canceled after S550-SFWv3 main unit started up.

"0","1" Programming completed successfully.

"0","2" Occurs when failed in mode entry before programming.

"0","3" Occurs when failed in checking IDs.

"0","4" Occurs when failed in erasing.

"0","5" Occurs when failed in programming.

"0","6" Occurs when failed in verifying.

"0","7" Occurs when failed in Blank.

"0","8" Occurs when failed in Protect.

9.5. Execution Detail Screen List

Error Descriptions

Pass Programming completed successfully.

Mode Entry Err Occurs when failed in mode entry before programming.

・Error factor in ”Factor”

ID Err Occurs when failed in checking IDs.

・Error factor in “Factor”

Erase Err Occurs when failed in erasing.

・Error factor in “Factor”

・Erase method in “Erase Type”

・Erase block number in “Block No”

Program Err

Occurs when failed in programming.

・Error factor in “Factor”

・Program execution address in “Address”

Blank Err Occurs when failed in Blank.

・Error factor in “Factor”

Verify Err Occurs when failed in verifying.

・Error factor in “Factor”

・Verify execution address in “Address”

・Expectation data in “Write Data”

・Actual data (read value) in “Read Data”

Protect Err Occurs when failed in protect.

・Error factor in “Factor”

Serial Flash Programmer[S550-SFWv3] Operation Manual 112

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 119 120

Sin comentarios

Renesas SuperH SH7280 Series Manual de usuario Pagina 113