Renesas SuperH SH7280 Series Manual de usuario descargar pdf (Pagina 97)

8. Stand-alone Mode

8.1. Stand-alone Programming

8.1.1. Process Flow up to Programming

The following section describes the operations from setting the programming data on the control software to actually

programming the target.

There are two ways of programming for you to choose from according to your operating environment:

- Stand-alone programming (Directly programming the target by S550-SFWv3)

- Remote programming (Programming the target from the control software via S550-SFWv3)

Stand-alone

programming

Download

Maintenance

setting

Data setting

Set maintenance setting (buzzer, password) i

the control software.

Set program data setting (device, data, block) o

the control software.

Store data set on the control software i

SFWv3.

After disconnecting (USB) from the PC an

connecting the target board, press the “Start”

switch on the main unit to start programming.

Serial Flash Programmer[S550-SFWv3] Operation Manual 96

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 119 120

Sin comentarios

Renesas SuperH SH7280 Series Manual de usuario Pagina 97