Renesas SuperH SH7600 Series Manual de usuario descargar pdf (Pagina 8)

1.2 Connecting the E10A-USB Emulator with the User System

To connect the E10A-USB emulator (hereinafter referred to as the emulator), the H-UDI port

connector must be installed on the user system to connect the user system interface cable. When

designing the user system, refer to the recommended circuit between the H-UDI port connector

and the MCU. In addition, read the E10A-USB emulator user's manual and hardware manual for

the related device.

Table 1.2 shows the type number of the E10A-USB emulator, the corresponding connector type,

and the use of AUD function.

Table 1.2 Type Number, AUD Function, and Connector Type

Type Number Connector AUD Function

HS0005KCU01H, HS0005KCU02H 14-pin connector Not available

1.3 Installing the H-UDI Port Connector on the User System

Table 1.3 shows the recommended H-UDI port connectors for the emulator.

Table 1.3 Recommended H-UDI Port Connectors

Connector Type Number Manufacturer Specifications

14-pin connector 2514-6002 Minnesota Mining &

Manufacturing Ltd.

14-pin straight type

Note: When designing the 14-pin connector layout on the user board, do not place any

components within 3 mm of the H-UDI port connector.

1.4 Pin Assignments of the H-UDI Port Connector

Figures 1.1 shows the pin assignments of the H-UDI port connector.

Note: Note that the pin number assignments of the H-UDI port connector shown on the

following page differ from those of the connector manufacturer.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Sin comentarios

Renesas SuperH SH7600 Series Manual de usuario Pagina 8