
M306H5T3-RPD-E User’s Manual 2. Setup
REJ10J0866-0100Z Rev.1.00 Dec.16, 2004
Page 20 of 66
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Removing/Attaching the Upper Cover
To use this emulation pod with your user system, it is necessary to set as follows. Set the following after removing the upper
cover.
Input frequency
Switches
Mounting/removing network resistors for pullup
(1) To open the upper cover, remove the four screws of both sides of this product and lift off the upper cover (see Figure 2.1)
(2) To close the upper cover, attach the upper cover and secure the four screws of both sides of this product.
Figure 2.1 Removing the upper cover
CAUTION
Note on Removing and Attaching the Upper Cover:
Always shut OFF power when removing/attaching the upper cover or changing the switch settings.
Otherwise the internal circuit may be damaged.
Comentarios a estos manuales