
E1/E20 Emulator Outline
R20UT0398EJ0400 Rev.4.00 Page 14 of 39
May 16, 2014
1.5. Regulatory Compliance Notices
1.5.1. European Union regulatory notices
This product complies with the following EU Directives. (These directives are only valid in the European Union.)
CE Certifications:
・Electromagnetic Compatibility (EMC) Directive 2004/108/EC
EN 55022 Class A
WARNING:
This is a Class A product. This equipment can cause radio frequency noise when used in the
residential area. In such cases, the user/operator of the equipment may be r
equired to take
appropriate countermeasures under his responsibility.
EN 55024
Information for traceability
Authorised representative
Name: Renesas Electronics Corporation
Address: 1753, Shimonumabe, Nakahara-ku, Kawasaki, Kanagawa, 211-8668, Japan
Manufacturer
Name: Renesas Solutions Corp.
Address: Nippon Bldg., 2-6-2, Ote-machi, Chiyoda-ku, Tokyo 100-0004, Japan
Person responsible for placing on the market
Name: Renesas Electronics Europe Limited
Address: Dukes Meadow, Millboard Road, Bourne End, Buckinghamshire, SL8 5FH, U.K.
Trademark and Type name
Trademark: Renesas
Product name: E1 Emulator / E20 Emulator
Type name: R0E000010KCE00 / R0E000200KCT00
Environmental Compliance and Certifications:
Waste Electrical and Electronic Equipment (WEEE) Directive 2012/19/EU
1.5.2. United States Regulatory notices
This product complies with the following EMC regulation. (This is only valid in the United States.)
FCC Certifications:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Comentarios a estos manuales