Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 19)

E1/E20 Emulator Setup

R20UT0398EJ0400 Rev.4.00 Page 19 of 39

May 16, 2014

2.3. Connecting the Emulator to the User System

Use the procedure below to connect the emulator to the user system with the user-system interface cable, or to

disconnect them when moving the emulator or the user system.

(1) Connect the user-system interface cable to the user-side connector of the emulator.

When connecting the user-system interface cable to the E1 emulator, check the position of the erroneous

insertion prevention key to ensure that the cable is plugged in correctly.

When connecting the user-system interface cable to the E20 emulator, check to see that the cable is plugged in

correctly, with the TOP side of its connector cover up.

USER I/F

User-side connector

USER I/F

User-side connector

E1 Emulator

E20 Emulator

Figure 2.2 User-Side Connector on the E1 and E20

CAUTION

Notes on connector insertion and removal:

When connecting or disconnecting the user-

system interface cable and the emulator or user system,

grasp the connector cover at the end of the cable. Pulling the cable itself will damage the wiring.

Also, be aware that the user-system

interface cable has the direction in which it must be inserted. If

the cable is connected in the wrong direction, it may break down.

Correct example

Incorrect example

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 38 39

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 19