Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 30)

E1/E20 Emulator Appendix A

R20UT0398EJ0400 Rev.4.00 Page 30 of 39

May 16, 2014

A.2 Preparations for Self-Checking

(1) The following items are required to execute the self-checking program.

 E1 or E20 emulator

 USB interface cable (included in the package)

 User interface cable (included in the package)

 Installation medium (included in the package)

 Host computer

The emulator software and USB driver must also be installed on the host computer in advance.

(2) Open the lid of the self-checking connector on the emulator. Then connect the user-side connector and self-

checking connector via the user interface cable.

E1 Emulator

E20 Emulator

ACT RESET

VCC

SELF CHECK

RUN

User-side connector

Lid

Self-checking

connector

TOP

ACT RESET

VCC

RUN

elf

-checking

Lid

User-side connector

connector

Figure A.1 Connecting the User Interface Cable (for the E1 and E20)

CAUTION

Insert the user interface cable firmly into the self-

checking connector. If the connection is loose, the

result will be “FAIL”.

(3) Start up the host computer. Connect the host computer and the emulator via the USB interface cable and turn

on the power for the emulator. The timing with which the supply of power starts differs with the emulator.

E1: The supply of power starts when the USB interface connector is connected.

E20: The supply of power starts when the power switch is turned on after the USB interface cable has been

connected.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 30