Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 36)

E1/E20 Emulator Appendix A

R20UT0398EJ0400 Rev.4.00 Page 36 of 39

May 16, 2014

In the case of failure, the word “FAIL” is displayed, followed by an error message in the center of the window.

Table A.1 lists the error messages.

Figure A.11 Display for an Error Found in Self-Checking

Clicking on the [LOG] button opens the file selection dialog box. Specify the location where you want the results

of self-checking to be saved. The results of self-checking are saved as a text file.

Table A.1 Error Messages

Message

Description

The E1/E20 self-check has failed.

The user interface cable was connected to the user system at

the time the self-

checking program was started or there is a

fault in the emulator.

If the fault falls under the warranty conditions given in section 7,

“Maintenance and Warranty”

, we will correct the fault or replace

the product for free. Correction or replacement in

other cases

incurs a fee.

Please connect the user interface cable with

the self-check connector in a correct direction.

Correctly connect the user interface cable to the self-checking

connector before starting the self-checking program.

An error occurred during USB I/O processing.

The USB interface cable was disconnected from the emulator

during self-

checking or there is a fault in the emulator. Connect

the USB interface cable and restart the self-checking program.

If the error recurs, it is due to a fault in the emulator.

If the FAIL is displayed in the other error, please request the repair because the product is defective.

1 2 ... 31 32 33 34 35 36 37 38 39

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 36