Renesas Emulator System SH7362 Manual de usuario descargar pdf (Pagina 16)

E1/E20 Emulator Outline

R20UT0398EJ0400 Rev.4.00 Page 16 of 39

May 16, 2014

1.7. The Names of the Emulator Parts

The names of the emulator parts are given in Figures 1.4 to 1.6.

E1 Emulator

E20 Emulator

ACT RESET

VCC

SELF CHECK

RUN

(a)

(c)

(d)

(e)

(f)

(b)

TOP

SELF CHECK

ACT

RESET

VCC

RUN

(a)

(d)

(e)

(c)

(b)

(f)

(a) Logotype:

The casing bears the “RENESAS E1” or “RENESAS E20” logotype.

(b) Connector for

self-checking:

A connector for use in self-checking. The lid is usually closed because this connector is not

used during debugging. For details on the self-checking procedure, refer to appendix A.

Illuminated: The emulator is usable.

Blinking: The USB driver has not been recognized (e.g. the USB driver has not correctly

been installed).

Not illuminated: The emulator is not usable for some reason.

(d) VCC LED: Marked ‘VCC’. This LED indicates the current state of power supply to the user system.

Illuminated (orange): The emulator is supplying power to the user system.

Illuminated (yellowish green): External power for the user system is on.

Not illuminated: The user system is not being supplied with power.

(e) RESET LED: Marked ‘RESET’. This LED indicates whether or not the signal on the MCU RESET pin of the

user system is being enabled.

Illuminated: The reset signal is enabled.

Not illuminated: The reset signal is disabled.

(f) RUN LED: Marked ‘RUN’. This LED indicates whether or not the MCU on the user system is running.

Illuminated: The user program is running.

Not illuminated: A break in execution of the user program

Figure 1.4 E1 and E20 Top View

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 38 39

Comentarios a estos manuales

Sin comentarios

Renesas Emulator System SH7362 Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Renesas Emulator System SH7362