Renesas User System Interface Board HS7047ECH61H Manual de usuario descargar pdf (Pagina 175)

4.6 Executing the Program

Execute the program as described in the following:

• To execute the program, select [Go] from the [Debug] menu, or click the [Go] button on the toolbar.

Figure 4.7 [Go] Button

While the program is executed, the current address bus value and the operating state of the MCU are displayed

on the status bar.

The program will be executed up to the software breakpoint that has been set, and an arrow will appear on the

[S/W Breakpoints] column in the [Editor] window to show the position where the program has halted, with the

message [Break = Software Break] in the status bar.

Notes: When the source file is displayed after a break, a path of the source file may be inquired. The location

of the source file is as follows:

OS installation drive \Workspace\Tutorial\E6000H\7046\Source

The directory mentioned above cannot be specified depending on the version of the software. In such

cases, specify the following directory instead.

High-performance Embedded Workshop installation destination directory

\Tools\Renesas\DebugComp\Platform\E6000H\7046\Source

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 242 243

Sin comentarios

Renesas User System Interface Board HS7047ECH61H Manual de usuario Pagina 175