Renesas User System Interface Board HS7047ECH61H Manual de usuario descargar pdf (Pagina 77)

Section 4 Diagnostic Test Procedure

This section describes the diagnostic test procedure using the E6000H diagnostic program.

4.1 System Set-Up for Diagnostic Program Execution

To execute the diagnostic program, use the following hardware; do not connect the user system interface board

and user system.

• E6000H (HS7046EPH60H)

• Host computer

• The E6000 PC interface board which will be one of the following boards:

PCI bus interface board (HS6000EIC01H or HS6000EIC02H)

PC card interface (HS6000EIP01H)

LAN adapter (HS6000ELN01H)

USB adapter (HS6000EIU01H or HS6000EIU02H)

1. Install the E6000 PC interface board in the host computer and connect the supplied PC interface cable to the

board.

2. Connect the PC interface cable to the E6000H.

3. Connect the supplied AC power cable to the E6000H.

4. Initiate the host computer to make it enter the command input wait state of the DOS prompt (Windows

98SE or Windows

Me) or command prompt (Windows NT

, Windows

2000, or Windows

XP). If the

property of the prompt window is not a mode for displaying the whole screen, press the [Alt + Enter] key to

switch the mode. To set back the mode, press the [Alt + Enter] key. The display of the screen is switched

regardless of the OS being used.

Note: In the MS-DOS prompt, if the display of the screen is not switched after pressing the [Alt + Enter] key,

mark the [Alt+Enter] check box in [Windows shortcut keys] of the [Misc] page on the [MS-DOS Prompt

Properties] dialog box and click the [Apply] button to update the settings, as shown in figure 4.1.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 242 243

Sin comentarios

Renesas User System Interface Board HS7047ECH61H Manual de usuario Pagina 77