Renesas H8S/2111B Manual de usuario descargar pdf (Pagina 124)

100

101

Rev. 1.00, 05/04, page 90 of 544

5.8 Usage Notes

5.8.1 Conflict between Interrupt Generation and Disabling

When an interrupt enable bit is cleared to 0 to disable interrupt requests, the disabling becomes

effective after execution of the instruction. When an interrupt enable bit is cleared to 0 by an

instruction such as BCLR or MOV, and if an interrupt is generated during execution of the

instruction, the interrupt concerned will still be enabled on completion of the instruction, so

interrupt exception handling for that interrupt will be executed on completion of the instruction.

However, if there is an interrupt request of higher priority than that interrupt, interrupt exception

handling will be executed for the higher-priority interrupt, and the lower-priority interrupt will be

ignored. The same rule is also applied when an interrupt source flag is cleared to 0. Figure 5.10

shows an example in which the CMIEA bit in the TMR's TCR register is cleared to 0.

The above conflict will not occur if an enable bit or interrupt source flag is cleared to 0 while the

interrupt is masked.

Internal

address bus

Internal

write signal

CMIEA

CMFA

CMIA

interrupt signal

TCR write cycle

by CPU

CMIA exception handling

TCR address

Figure 5.10 Conflict between Interrupt Generation and Disabling

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 581 582

Comentarios a estos manuales

Sin comentarios

Renesas H8S/2111B Manual de usuario Pagina 124

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Renesas H8S/2111B