Renesas Technology, Tools FAQs
Last Updated: August 25, 2000
Document Number: 01050932_e
Q.
Every time I startup the PD79 debugger, I get the following error message: "Processor mode and target system do not match". This
message is displayed no matter what processor mode I specify. How can I avoid this error message?
A.
Check to make sure that the voltage of the Vss pin is GND (0V). The same error will occur if the single chip mode or memory
expansion mode is selected in the EMEM dialog when MD0 and MD1 pin levels differ from the Vss pin voltage.
1.
Make sure the BYTE pin is left open (floating).2.
This error massage may happen when any connection point between the target and the POD has a loose or bad connection.
Please check every target and POD contact point.
3.
Top of Page | Back to Previous Page
Terms of Use Privacy Policy
(C)2004 Renesas Technology Corp., All Rights Reserved.
Comentarios a estos manuales