Renesas Technology, Tools FAQs
Last Updated: January 20, 2003
Document Number: 02111901_e
Q.
When I start up the emulator debugger M3T-PD38, the "ERROR 16215" is displayed and the emulator will not operate.
A.
ERROR 16215 is generated when the M3T-PD38 start-up or restart (during operations) process did not occur successfully.
Please confirm the following items to ensure proper operations.
Are power, GND and clock being supplied to the target system within the range of the MCU specifications?1.
Is the normal voltage level (default = High) being supplied to the RESET and ONW* pins?
(The emulator will not work if the RESET pin or ONW*pin is fixed to "L".)
2.
Is the switch on the emulation pod set properly (RSS/RFS side or RLSS/RLFS side) and is the VCC cable connected
properly?
For RSS/RFS type emulation MCUs:
Set the emulation pod switch to RSS/RFS and leave the VCC cable open (unconnected)
For RLSS/RLFS type emulation MCUs:
Set the emulation pod switch to RLSS/RLFS and connect the VCC cable to the target system.
3.
Is the emulation pod RESET cable connected to the target MCU reset input pin?4.
Has the correct MCU file been selected in the M3T-PD38 Init dialog?5.
Are you using an "H" output type RESET IC on the target board as MCU reset circuit?
* When debugging with M38000TL2-FPD, use either an open-drain type reset IC or an CR reset circuit.
The recommended pull-up value is about 10k ohms. The MCU can be reset by outputting "L" to the target through the reset
clip on the M38000TL2-FPD.
However, if the reset circuit on the target is an H-output type RESET IC, it cannot be set to "L" and the emulator will not
operate properly.
6.
Was the emulator self-check executed successfully?
* The self-check will generate an error if the emulator or emulation pod is malfunctioning or the target is not connected
properly. Please check the emulation pod instructions for more details on how to perform the self-check.
7.
The above settings and requirements are provided in detail in the emulation pod instructions.
Top of Page | Back to Previous Page
Terms of Use Privacy Policy
(C)2004 Renesas Technology Corp., All Rights Reserved.
Comentarios a estos manuales