Renesas Technology, Tools FAQs
Last Updated: July 5, 2000
Document Number: 01050805_e
Q.
I would like to know how to change the oscillation circuit of the M34551T2-MCU board to CR oscillation.
A.
The M34551T2-MCU board does not work with CR oscillation. You must use the evaluation MCU for the CR oscillation
evaluation.
[Supplement]
When the PC4504 emulator MCU board uses the X
OUT
pin as an output pin in the emulation mode operation, the X
IN
pin is only
available for chip oscillation. Therefore, CR oscillation, which requires both X
IN
and X
OUT
pins, is not possible on this board.
Top of Page | Back to Previous Page
Terms of Use Privacy Policy
(C)2004 Renesas Technology Corp., All Rights Reserved.
Comentarios a estos manuales